User's Manual

MicroPower Technologies
1-877-536-0128 | micropower.com
14
Changing RF Channels
On the Solveil system, a hub will always default to the same radio channel (just as there is a default IP address)
thus channel selecon is very important, parcularly if there are mulple hub systems operang in the same
general area. Never run two Solveil systems on the same channels, within range of each other, or there will very
likely be signicant loss of system performance.
Video Channel: Represents the 2.4GHz channel that the video is transmied on, from the camera to the hub.
There are (3) choices, 2, 6, and 11. Try to choose a channel
that has the least amount of trac present.
Control Channel: Represents which small secon of the
video channel is also used for the camera to communicate
with the hub, via 2-way communicaon.
Be sure to click “Save” when you have completed making
your channel selecons.
Security Note: The camera system does not communicate
using any form of WiFi, and that the video signals and
communicaon signals do not contain any IP addresses,
or network data. This provides an enhanced layer of security because the
system never transmits any network related data that could compromise
the security of the host network. All networking tasks, are handled
internally in the hub, and transmied via the ethernet port, never via the
wireless network.
Adding Cameras
On MicroPower systems, individual cameras are never actually part of your computer network. Cameras are
idened to the hub by the MAC address that is assigned to the camera. This MAC address can be located on a
scker that can be found on the exterior and the interior of the camera. Generally they will resemble the following
structure: “48:17:4C:02:xx:xx” (“xx:xx” will vary from camera to camera). Make a note of all of the camera MAC
addresses in a given system and where those cameras are installed.
1. When logged into the hub click on the “Cameras” tab, and then on “Add/Delete”, here you will see a list of
cameras that are currently added to the hub (click the “refresh” buon to populate the list). The list should be
blank if you are seng up a hub for the rst me. If the hub is new, and you see a camera already added, click the