User's Manual

Table Of Contents

Helios Installation Guide

II. System Setup

The following steps are required when performing system setup and installation.

1. Connect the antennae to the video hub

2. Configure video hub to the desired IP address/network settings.

3. Reboot the hub system.

4. Add the camera(s) MAC address through the hub’s web interface.

5. Connect the camera antenna and camera power to test the each camera prior to

mounting and installation.

6. View the camera connection through the web interface and Live Connection

(Perform basic adjustments to camera zoom/focus settings if necessary).

7. Mount the video hub in a secured, climate controlled location, run the hub

antenna cable, mount and adjust hub antenna.

8. Begin camera, antenna, and solar panel mounting, and adjust antenna alignment

at the final remote installation locations.