User's Manual

Helios Installation Guide
© 2012 MicroPower Technologies, Inc. 17
D. Camera Settings
The tab, “Camera Settings” is used to customize each wireless camera associated with
the paired video hub.
1. Select tab labeled Camera Settings.
Variables for the Camera Settings beyond the MAC address are:
Variable Description
Valid value for
wireless cameras
MAC
Camera MAC Address
Six Hex values
WB Power
Power settings for the Wideband signal
Hi, Med, Lo
Demod
Data bandwidth of the individual
cameras
54, 48, 36, 24 Mbps
Fr. Rate
Frame rate desired.
(Fixed at 5fps)
Invert State
Specifies whether the video is an
inverted image or not.
Off
Encrypt State
Will allow the encryption of data sent
between the wireless and video hub .
(Inactive: Future Development Feature)
Off
Stream
Displays the stream # of the camera.
(This information is needed to set up
most VMS configurations)
StreamX where X can
be 0 to 5
Use the “Apply” button at the end to apply new settings for that specific camera.
Helpful Tip: Make a note of the stream numbers associated with each of your cameras,
it is helpful to have when setting up the VMS software.
The “Align” button is used for aligning antennas, and is covered in the next section.