User's Manual

Table Of Contents

Helios Installation Guide

wireless camera is shipped from the factory, the battery is disconnected from the

battery camera to ensure it remains fully charged.

When the battery is connected to the camera, an LED indicator light (on the left side

while peering inside the camera) should glow red when the battery is connected.

4. If you wish to do an initial camera focus / zoom adjustment, you can leave the camera

open. Otherwise, close the camera housing then lock the safety latch.

NOTE: When closing the housing, be careful not to crush any cables in the housing

hinges or edge seals, and make sure the various water-tight seals remain in place on the

edges of the housing. (particularly at the front of the camera near the hinges)

Helpful Tip: Make a note of the MAC address in your records. (If you ever need to re-set

up the hub, it is helpful to have these numbers written down, instead of having to visit

each camera after it has been installed)