User's Manual

Table Of Contents

Helios Installation Guide

C. Add/Remove Cameras

This is the menu used to add or remove cameras that are associated with the specific

hub that is being configured.

1. Select Tab labeled Add/Remove Camera.

2. Select option to “Add New”. A pop-up window for the MAC address of the camera is

displayed.

Add the MAC Address that is printed on the sticker of the wireless camera. The sticker is

located both on the inside and the outside of the camera enclosure.

Press OK when the MAC address is entered.

1. Follow Step 3 again to add additional cameras (maximum of 6)

2. Connect the antenna(s) to the camera(s)

3. Inside the camera enclosure, connect the battery cable to the camera circuit board

connector. The camera ships with a fully charged battery pack, however, when the