User's Manual

Table Of Contents

Helios Installation Guide

To configure the video hub, you will need to:

1. Connect video hub Antenna

2. Connect the AC power cable to the video hub and plug into a power source.

3. Power on the video hub by briefly pressing the power button on the rear of the unit. If

the camera is powered on, make sure the wireless camera and video hub antennas are

at least 25 feet away from each other.

4. Connect your computer to the hub via the Ethernet port, and configure your computer

network settings so that it can directly address the video hub.

Below is an example screen of modifying the IPv4 IP address properties in Windows to make

this change.

Press OK.