User`s guide

Appendix A
9
register about to Init for Date and Time. CMOS status register about to Init for Date
and Time. Refresh on and about to start 64K base memory test. Confirmed refresh
ON & abou
t to start 64K memory.
AST
(10)DMA controller test 0 register
Award
(10)DMA channel 1 Test. Test DMA controller 1 with AA, 55,FF,00 pattern.8237
DMA,channel 0 test.
Compaq
(10)PPI disabled, Program timers 0 & 1.
Chips & Tech
(10)(Beeps)=19 short, IDT,G
DT failure.
Phoenix&Dell
(10)Initialize Power Management.(Beep)=1
-
2
-
1
-
1.Initia
-
lize 8254
timers.[Beep]=2
-
1
-
1 1st 64K RAM chip or data line failure
-
bit 0.
Error Code
–
11
AMI
(11)Pin23,24 of keyboard controller is blocked/unblocked. Going to check to c
heck
pressing of <INS>key during power-
on.CMOS status register initialized.Going to
disable DMA and Interrupt controllers. Going to disable DMA and interrupt
controllers. Address line test passed. Address line test passed.
AST
(11)DMA controller test regi
ster 1.
Award
(11)DMA page register test. Test DMA page registers,use I/O ports to test address
circuits. POST enables user reboot here.Test DMA page registers. FATAL
DISPLAY ER
-
RORS.8237 DMA,channel 1 test.
Compaq
(11)Init(blast)VDU controllers.
Chips
& Tech
(11)Register LDT failure.
Phoenix&Dell
(11)Load alternate registers with POST values.(Beep)=1
-
2
-
2. 1st 64K RAM chip or
data line failure
-
bit 1.
Error Code
–
12
AMI
(12)Checking for pressing of <INS>key during power
-
on done. Going to disable
DM
A and Interrupt controllers.DMA controller#1,#2,interrupt controller#1,#2
disabled. About to disable Video display and Init port-
B. About to disable video
display and Init port-
B.64K base memory test passed. 64K base memory test
passed.
AST
(12)DMA page r
egisters test.
Award
(12)Call support 800
-
909
-
3424. Test 8254 timer 0 channel 0. Test DMA page
registers.
Compaq
(12)Clear screen, turn on video.
Chips & Tech
(12)Task register failure.
Phoenix&Dell
(12)Restore CPU control word during warm boot. Jump t
o User Path
0.(Beep)=1-2-1-
3.Test both 8237 DMA controllers. 1st 64K RAM chip or data line
failure
-
bit 2.
Error Code
–
13
AMI
(13)DMA controller#1,#2,interrupt controller#1,#2disa
-
bled. About to disable
Video display and initialize port-B. Chipset init
ialize/auto memory detection about
to begin. Replace first memory SIMM.(13)Chipset initialize/auto memory detection
about to begin. Check first SIMM.(13) Interrupt vectors initialized.
AST
(13)Initialize video.
Award
(13)Test 8254 timer 0 channel 1. Test
keyboard controller.
Compaq
(13)Test timer 0.
Chips & Tech
(13)LSL instruction failure.
Phoenix&Dell
[Beep]=2
-
1
-
4 1st 64K RAM chip or data line failure
-
bit 3. Initialize PCI Bus
Mastering devices.
Error Code
–
14
ACER
(14)DMA Controller.
AMI
(14)Ch
ipset initialization/auto memory detection over. To un
-
compress the POST
code if compressed BIOS.8254 timer test about to start.8254 timer test about to
start.8042 keyboard controller test OK.
AST
(14)Memory refresh test.
Award
(14)Test 8254 timer 0 coun
ter 2. Test timer counter 2; Test 8254 timer 0 counter 2.
Test memory refresh.
Compaq
(14)Disable RTC interrupts.
Chips & Tech
(14)LAR failure.
Phoenix&Dell
(14)Initialize keyboard controller.(Beep)=1
-
2
-
2
-
1.Initialize 8237 DMA
controllers.[Beep]=2
-
2
-
1 1
st 64K RAM chip or data line failure
-
bit 4.
Error Code
–
15
AMI
(15)POST code is un
-
compressed.8254 timer about to start. CH
-
2 timer test
halfway.8254 CH-2 timer test to be complete.8254 CH-
2 timer test to be completed.
Interrupt vectors initialized. CM
OS read/write test OK.
Award
(15)test 8259 interrupt mask bits for channel 1. Test 8259
-
1 mask bits; Verify 8259
channel 1 masked interrupt by alternate turning off and on the interrupt line. Test 1st
64K of system memory.
Compaq
(15)Check battery power.
Chips & Tech
(15)VERW/VERR failure.