User`s guide

Appendix A
17
an
d interrupt controller test. Master 8259 mask register OK, about to start slave.
Compaq
(59)Check existence of adapter.
Chips & Tech
(59)Exiting protected mode.
Phoenix
(59)Initialize POST display service.
Error Code
–
5A
AMI
(5A)About to check timer
and keyboard interrupt level.
Compaq
(5A)Blank display, check VDU registers.
Chips & Tech
(5A)Board memory size.
Phoenix
(5A)Keyboard ready test. Display prompt “press F2 to enter
SETUP”.(Beep)=2
-
2
-
3
-
3
Error Code
–
5B
AMI
(5B)Timer interrupt OK.
Co
mpaq
(5B)Start screen memory test.
Chips & Tech
(5B)Shadow RAM relocated.
Phoenix
(5B)Display CPU cache.
Error Code
–
5C
ACER
(5C)About to test keyboard and I/O.`
AMI
(5C)About to test keyboard interrupt.
Compaq
(5C)End of test of adapter, clear mem
ory.
Chips & Tech
(5C)EMS configure.
Phoenix
(5C)Test RAM between 512 and 640K.(Beep)=2
-
2
-
4
-
1. Determine if AT or KT
keyboard type.
Error Code
–
5D
AMI
(5D)ERROR! Timer/keyboard interrupt not in proper level.
Compaq
(5D)Error detected on an adapter.
Chips & Tech
(5D)Wait state configuration is set
-
up.
Error Code
–
5E
AMI
(5E)8259 interrupt controller error.
Compaq
(5E)test the next adapter.
Chips & Tech
(5E)1st 64K RAM re
-
test.
Phoenix
(5E)Enter third protected mode test.
Error Code
–
5F
AMI
(5F)8259 interrupt controller test OK.
Compaq
(5F)All adapters successfully tested.
Chips & Tech
(5F)Shadow RAM.
Error Code
–
60
ACER
(60)Set up BIOS interrupt.
AMI
(60)DMA page register test passed. About to go for DMA #1,verify from display
memory
.
AST
(60)RAM size.
Award
(60)Setup virus protection(Boot sector protection).
Compaq
(60)Start of memory test.
Chips & Tech
(60)CMOS RAM.
Phoenix
(60)Test expanded memory.(Beep)=2
-
3
-
1
-
1.(60)Base memory test.
Error Code
–
61
AMI
(61)Display memory v
erification over. About to go for DMA #1 base register test.
AST
(61)RAM test.
Award
(61)Try to turn on level 2 cache. Set the boot up speed according to setup setting.
Last chance for chipset initialization. Last chance for power management
initializati
on. Show the system configuration table.
Compaq
(61)Enter protected mode.
Chips & Tech
(61)Video.
Error Code
–
62
AMI
(62)DMA#1 base register test passed. About to go for DMA #2 base register test.
AST
(62)Shadow RAM.
Award
(62)Setup daylight saving
according to setup values. Program the NUM lock, type
rate & type speed according to setup setting. Setup NUM_LOCK; Setup
NUM_LOCK status according to setup.
Compaq
(62)Start memory sizing.
Phoenix
(62)Test extended memory address lines.(Beep)=2
-
3
-
1
-
3.
Base memory address
test.
Error Code
–
63
AMI
(63)DMA #2 base register test passed. About to go for BIOS ROM data area check.
AST
(63)Cache memory.
Award
(63)If there is any changes in the hardware configuration, update the ESCD
information(PnP BIOS o
nly. Clear memory that have been used. Boot system via
INT 19h.
Compaq
(63)Get CMOS size.
Chips & Tech
(63)Protected mode interrupt.