User manual

refresh.(Beep)=1-3-1-1. Upper 16 of 32 bit test failed.
(21) [Beep]=3-1-2 slave DMA register test in -progress or failure.
(22) [Beep]=3-1-3 master interrupt mask register test in - progress or fail. Test
8742 keyboard controller.(Beep)=1 - 3-1-3
(23) [Beep]=3-1-4 slave interrupt mask register test in -progress or fail.
(24) Set ES segment to register to 4 GB.(beep)=1 -3-2-1. Verify CMOS/Configure
CMOS.
(25) [Beep]=none interrupt vector loading in-progress.
(26) Enable A20 line. Verify/Load NVRAM parameters.
(27) [Beep]=3-2-4 keyboard controller test in -progress or failure.
(28) [Beep]=3-3-1 CMOS power-fail and checks um checks in -progress. Auto -size
DRAM.(Beep)=1 -3-3-1.Protected mode 1.
(29) [Beep]=3-3-2 CMOS configuration info validation in - progress. Initialize
POST Memory Manager.
(2A) Clear 512K base RAM.(Beep)=1 -3-3-3.Aubo-site memory chips.
(2B) [Beep]=3 -3-4 screen memory test in-progress or failure.
(2C)RAM failure on address xxxx. If the BIOS detects error 2C,2E,or 30(base 512K
RAM error),it displays and additional word –bitmap (xxxx) indication the address
line
or bits that failed. For example, "2C 0002"means address line 1 (bit one set) has
failed. "2E 1020 means data bits 12 and 5 (bits 12 and 5 set) have failed in the
lower
16 bits. Note that error 30 cannot occur on 386SX systems because the y have a
16
rather than 32-bit bus. The BIOS also sends the bitmap to the port -80 LED display.
It
first display the check point code, followed b y a delay, the high -order byte,
another
delay, and then the low-order byte of the error. It repeats this sequence
continuously.
Test 512 base address lines.(Beep)= 1-3-4-1 Activate interleave(if
possible).[Beep]3-4-1 screen initialization in -progress or failure.
(2D) [Beep]=3-4-2 screen retrace tests in -progress or failure.
(2E) See Error code "2C". Test 512K base memory.(Beep)= 1-3-4-3.Exit 1st
protected
mode test.[Beep]=none search for video ROM in -progress.
(2F) Enable cache before system BIOS shadow.
(30) see Error Code "2C".Unexpected shutdown.[Beep]=no - ne screen believed
operable. [Beep]=none screen believed running w/video ROM.
(31) [Beep]=none monochromatic screen believed operable.
(32)Test CPU bus-clock frequency.(Beep)=1-4-1-3.Deter- mine system board
memory size. [Beep]=none 40-column color screen believed operable.
(33) [Beep]=none 80 -column color screen believed operable. Initialize dispatch
Manager.
(34) [Beep]=4-2-1 timer tick interrupt test in progress or failure. Relocate memory
option.
24