User manual

BIOS data area. Initialize time value; Initialize time value in 40h BIOS data area.
(55) Check PCI video Card -or replace video card.
(60) Setup virus protection(Boot sector protection).
(61) Try to turn on level 2 cache. Set the boot up speed according to setup setting.
Last chance for chipset initialization. Last chance for power management
initialization. Show the system configuration table.
(62) Setup daylight saving according to setup values. Program the NUM lock, type
rate & type speed according to setup setting. Setup NUM_LOCK; Setup
NUM_LOCK status according to setup.
(63) If there is any changes in the hardware configuration, update the ESCD
information n(PnP BIOS only. Clear memory that have been used. Boot system via
INT 19h.
(B0) Spurious interrupt occurred in protect mode. Check mismatch memory.
(B1) If unmasked NMI occurs, Press F1 to disable NMI,F2 to boot.
(BE) Program defaults values into chipset.(BE)Chipset default initialization;
Program chipset registers with power on BIOS defaults.
(BF) Program the rest of the chipset (BF)Chipset initialization; Program chipset
registers with setup values.
(C0) Turn off chipset cache; OEM Specific -cache control.
(C1) Memory presence test; OEM specific-test to size on - board memory. Bad
SIMM.
(C3) DRAM Select page, Check BIOS setting and first SIMM, Possible address line
failure.
(C4) CMOS conflicts, check video switch, BIOS(Chipset) on the video not
initializing.
(C5) Early shadow; OEM Specific -Early shadow enable for fast boot.
(C6) Cache presence test; External cache size detection. (Check Memory first
64K.Check CPU jumper Setting). Also, Check Video memory
(C7) Shadow video/system BIOS after memory pass.
(C8) CMOS Shutdown, time delay.
(CA) Micronics cache initialization.
(CC) NMI handler shutdown.
(FF)System booting. This means that the BIOS already passed control to the
operation system. If no error flags such as memory size are set ,boot via INT 19
-load
system from drive A, then C; display error message if correct boot device not
found.
Boot system.
(EE)Unexpected Processor exception.
Phoenix
(01) [Beep]=none 80286 register test in progress.
(02) Verify real -mode operation(Beep)=1 -1-1-3.CPU Flags test.
(02) [Beep]=1-1-3 CMOS write/read test in -progress or failure.
(03) Disable Non-Maskable Interrupt(NMI).[Beep]=1 -1-4 BIOS ROM checksum
in-progress or failure.
22