User manual

ROMs.
(32) Display the Award Plug & Play BIOS extension message(PnP BIOS only).Test
EISA extended memory; If EISA mode flag is set then test EISA memory found in
slots initialization, T his test is skipped in ISA mode and can be skipped with ESC
key in EISA mode.
(33) Call Tech Support 727 -532-4151.
(36) Warm Start shut down.
(38) shadow system BIOS ROM.
(3A) Auto size cache.
(3C) Advanced configuration of chipset registers.
(3D) Initialize keyboard. Install PS/2 mouse. Initialize & install mouse; Detect if
mouse is present, initialize mouse, install interrupt vectors.
(3E)Try to turn on level 2 cache.
(3F) Enable shadow RAM per CMOS RAM setup or if MEMORY TYPE is SYS in the
EISA configuration.
(40) Display virus protest disable or enable.
(41) Initialize floppy disk drive controller.
(42) Initialize hard drive & controller; Initialize hard drive controller and any
drives.
(43) If it is a PnP BIOS, initialize serial & parallel ports. Detect & initialize
serial/parallel ports; Initialize any serial and parallel ports (also game port).
(44) Going to initialize data to check memory re -map at 0:0.
(45) Detect & Initialize math Coprocessor; Initialize math Coprocessor.
(46) Display the setup message(to press Ctrl -Alt-Esc to enter setup), and enable
setup.
(47) Set system speed for boot.
(48) Check video configuration against CMOS.
(49) Initialize PCI bus and devices.
(4A) Initialize all video adapters in system.
(4B) QuietBoot start (optional).
(4C) Shadow video BIOS ROM.
(4E) If there is any error, show all the error messages on the screen & wait for user
to press<F1>. Manufacturing POST loop or display messages; Reboot if
manufacturing POST loop pin is set. Otherwise display any messages and enter
setup.
(4F) If password is needed, ask for password. Clear the Energy Star logo (Green
BIOS only). Security check; Ask password security.
(50) Write all the CMOS values currently in the BIOS stack areas back into the
CMOS. Write CMOS; Write all CMOS values back to RAM and clear screen.
(51) Pre-boot enable; Enable parity checker; Enable NMI, Enable cache before
boot.
(52) Initialize all ISA ROMs. Later PCI initializations(PCI BIOS only). PnP
initializations(PnP BIOS only). Program shadow RAM according to setup settings.
Program parity according to setup setting. Power Management initialization.
Initialize option ROMs; initialize any option ROMs present from C8000h to EFFFFh.
(53) If it is not a PnP BIOS, initialize serial & parallel ports. Initialize time value in
21