User manual

(83) Command byte written, global data Init done. About to check for lock -key.
Check for RS232 ports and put the addresses in global data area.
(84) Lock-key checking over. About to check for memory size mismatch with CMOS.
Co-Processor detection over. 80287 check/test OK.
(85) Memory size check done. About to display soft error and check for password
or bypass setup. About to display soft error message. If no video replace Video
card.
(86) Password checked. About to do programming before setup. About to give
control to system ROM at segment E000.
(87) Programming before setup complete. Going to uncompress SETUP code and
execute CMOS setup. System ROM E000:0 check over.
(88) Returned from CMOS setup program and screen is cleared. About to do
programming after setup.
(89) Programming after setup complete. Going to display power on screen
message.
(8A) First screen message displayed. About to display <WAIT…>message.
(8B) First screen message displayed <WAIT...> message displayed. About to do
Main and Video BIOS shadow.
(8C) Main and video BIOS shadow successful. Setup options programming after
CMOS setup about to start.
(8D) Setup options are programmed, mouse check and Init to be done next. Going
for hard disk, floppy reset.
(8E) Mouse check and initialization complete. Going for hard disk controller reset.
About to go For floppy check.
(8F) Hard disk controller reset done. Floppy setup to be done nest.
(90) Floppy setup is over. Test for hard disk presence to be done.
(91) Floppy setup complete. Hard disk setup to be done next.
(92) Hard disk setup complete. About to go for BIOS ROM data area check.
(93) BIOS ROM data area check halfway. BIOS ROM data area check to be
completed.
(94) Hard disk setup complete. Going to set base and extended memory size.
BIOS ROM data area check over.
(95) Memory size adjusted due to mouse support, hard disk type-47. Going to
verify from display memory.
(96) Memory size adjusted due to mouse support, hard disk type -47.Going to do
any Init before C800 optical ROM control. Returned after verifying from display
memory.
(97) Any Init before C800 optional ROM control is over. Optional ROM check &
control will be done next.
(98) Optional ROM control is done. About to give control to do any required
processing after optional ROM returns control.
(99) Any initialization required after optional ROM test over. Going to setup timer
data area and printer base address .
(9A) Return after setting timer and printer base address. Going to set the RS -232
base address.
(9B) Returned after RS-232 base address. Going to de any initialization before
16