User manual

(59) Hit<ESC> message cleared. <Wait..> message displayed. About to start
DMA and interrupt controller test. Master 8259 mask register OK, about to start
slave.
(5A) About to check timer and keyboard interrupt level.
(5B) Timer interrupt OK.
(5C) About to test keyboard interrupt.
(5D) ERROR! Timer/keyboard interrupt not in proper level.
(5E) 8259 interrupt controller error.
(5F) 8259 interrupt controller test OK.
(60) DMA page register test passed. About to go for DMA #1, verify from display
memory.
(61) Display memory verification over. About to go for DMA #1 base register test.
(62) DMA#1 base register test passed. About to go for DMA #2 base register test.
(63) DMA #2 base register test passed. About to go for BIOS ROM data area
check.
(64) BIOS ROM data area check halfway. BIOS ROM data area check to be
completed.
(65) DMA #2 base register test passed. About to program DMA unit 1 and 2.
(66) DMA unit 1 and 2 programming over. About to initialize 8259 interrupt
controller.
(67) 8259 initialization over. About To start keyboard test.
(70) Start of keyboard test.
(71) Keyboard controller BAT test over.
(72) Keyboard interface test over, mouse interface test started.
(73) Global data initialization for keyboard/mouse over.
(74) Display 'SETUP' prompt and about to start floppy setup.
(75) Floppy setup over.
(76) Hard disk setup about to start.
(77) Hard disk setup over.
(79) About to initialize timer data area.
(7A) Timer data initialized and about to verify CMOS batter y power.
(7B) CMOS batter y verification over.
(7D) About to analyze POST results. About to analyze diagnostic test results for
memory.
(7E) CMOS memory size updated.
(7F) Look for <DEL> key and get into CMOS setup if found. About to check
optional ROM C000:0.
(80) Keyboard test started, clearing output buffer, checking for stuck key, About to
issue keyboard reset command. About to give control to optional ROM in segment
C800 to DE00.
(81) Keyboard reset error/stuck key found. About to issue keyboard controller
interface test command. Optional ROM control over.
(82) Keyboard controller interface test over. About to write command byte and Init
circular buffer. Check for printer ports and put the addresses in global data area.
(83) Command byte written, global data Init done. About to check for lock -key.
Check for RS232 ports and put the addresses in global data area.
15