Specifications

4-14
Micronics M54Hi-Plus System Board Manual
APM
When enabled the power management features are active. The default setting
is Disabled. If you enable this category, you must also set the other power
management options below.
Power Management Mode
This category may be set for Maximum power savings, Medium power
savings, Minimum power savings, Customized, or Disabled (default). If you
set this category for Maximum, Medium, or Minimum power savings, you do
not need to make any more adjustments. If you select Customized, you must
set the following five categories.
Standby Timeout
The Standby Timeout category sets the amount of time that elapses for the
system to enter the power saving mode. The options are Disabled (default), 1
min., 15 min., 30 min., 45 min., 60 min., 2 hr., 3 hr., or 4 hr.. Before making
changes, “Customized” must be selected in the Power Management Mode
category.
Suspend Timeout
The Suspend Timeout category sets the amount of time that elapses for the
system to enter the Suspend Mode. The timer starts when the Standby Mode
is activated. The options are Disabled (default), 1 min., 15 min., 30 min., 45
min., 60 min., 2 hr., 3 hr., and 4 hr.. Before making changes, “Customized”
must be selected in the Power Management Mode category.
Standby CPU Speed
This category sets the CPU speed during power saving mode. The options are
Maximum, Medium, Minimum, and Slowest (default). Before making
changes, “Customized” must be selected in the Power Management Mode
category.
Fixed Disk Timeout
This category sets the amount of time which elapses before the IDE drive
enters spin-down mode to conserve power. The options are Disabled (de-
fault), 1 min., 2 min., 5 min., 10 min., or 15 min. Before making changes,
“Customized” must be selected in the Power Management Mode category.
Note:
Do not enable this category unless your IDE drive supports spin-down mode.