Specifications

3-6
Micronics M54Hi-Plus System Board Manual
Installing a CPU
The M54Hi-Plus is designed to a variety of Pentium processors. Follow the
steps below to install a processor:
1. Turn off the computer and remove its cover.
2. Locate the ZIF socket illustrated in Figure 2-1.
3. Lift the lever of the socket.
4. Locate pin 1 on the processor and pin 1 on the socket. Gently set the
processor into the socket, making sure pin 1 on the processor and
pin
1 on the socket are aligned.
5. Push the lever down until it locks into place.
6. Make sure the speed selection jumpers are set correctly (Chapter 2).
Warning:
Pentium processors require a heat-sink with a cooling fan. Failure to
provide adequate cooling of the processor may seriously affect system
performance or cause permanent damage to the processor.