Product manual

11 Configuring Serial or Ethernet Communication TAC Xenta Server – Gateway, Technical Manual
92 (184) Schneider Electric Buildings AB, June 2011
04-00124-06-en
11.2 The Communications Interface
You enable the communication on the RS-232/485 A port or the
10Base-T port on the Xenta 913 by adding an interface in your
XBuilder project. The interface specifies which protocol is used, which
port to use and parameters controlling the communication.
For more information about adding a communications interface, see
Section 4.1, “Adding a Modbus Master Interface”, on page 36.
Important
• To enable Ethernet communication to a remotely controlled
device you add an interface to the TCP-IP port in XBuilder, for
example a Modbus TCP Client.