User`s manual

6
3. Console Interface Configuration
3.1 Setting UP Connection
Users can configure the switch in command line via console port. The operating mode of
the console port is
y 9600 (Fix baud rate)
y n (No parity checking)
y 8 (8 Data bits)
y 1 (1 stop bit)
y None (No flow control)
After attaching a RS-232 cable to the serial port of a PC running a terminal emulation
program, press “Enter” key then login screen appears. Enter your password to login the
configuration UI. The default password is “admin”.
3.2 Main Menu
After key in the password, the main page will show as below. By default, all ports are set at
auto-negotiation and flow control on.
This switch provides the following management function:
Function Statement
System Configuration Provides Password, Aging time, Maximum broadcast,
Hash Algorithm and Jumbo packet configuration.
Port Status Provides ports configuration, including enable/ disable
ports, set-up duplex mode and flow control
VLAN Configuration Supports up to 8 groups port-base VLAN
Trunking Configuration Supports 2 port-trunk groups