User`s manual

– 90 –
C HAPTER 4 | Configuring the Switch
Configuring Security
3. Repeat the preceding step for each port to which an ACL will be applied.
4. Click Save.
Figure 29: ACL Port Configuration
CONFIGURING RATE L IMITERS
Use the ACL Rate Limiter Configuration page to define the rate limits
applied to a port (as configured either through the ACL Ports Configuration
menu (page 88) or the Access Control List Configuration menu (page 91).
P ATH
Configuration, Security, Network, ACL, Rate Limiters
P ARAM ETE R S
These parameters are displayed:
◆ Rate Limiter ID - Rate limiter identifier. (Range: 0-14; Default: 1)
◆ Rate - The threshold above which packets are dropped.
(Options: 0-100 pps, or 0, 100, 2*100, 3*100, ... 1000000 kbps)
Due to an ASIC limitation, the enforced rate limits are slightly less than
the listed options. For example: 1 Kpps translates into an enforced
threshold of 1002.1 pps.
◆ Unit - Unit of measure. (Options: pps or kbps; Default: pps)
WEB INTERFACE
To configure rate limits which can be applied to a port:
1. Click Configuration, Security, Network, ACL, Rate Limiters.
2. For any of the rate limiters, select the maximum ingress rate that will
be supported on a port once a match has been found in an assigned
ACL.
3. Click Save.