User`s manual

–

HAPTER

4 | Configuring the Switch

Configuring Security

WEB

NTE

FACE

To configure SNMPv3 views:

1. Click Configuration, Security, Switch, SNMP, Views.

2. Click “Add new view” to set up a new view.

3. Enter the view name, view type, and OID subtree.

4. Click Save.

Figure 24: SNMPv3 View Configuration

CONFIGURING SNMPV3 GROUP ACCESS R

IGHTS

Use the SNMPv3 Access Configuration page to assign portions of the MIB

tree to which each SNMPv3 group is granted access. You can assign more

than one view to a group to specify access to different portions of the MIB

tree.

ATH

Configuration, Security, Switch, SNMP, Access

ARAM

ETE

These parameters are displayed:

◆

Group Name - The name of the SNMP group. (Range: 1-32 characters,

ASCII characters 33-126 only)

◆

Security Model - The user security model. (Options: any, v1, v2c, or

the User-based Security Model – usm; Default: any)

◆

Security Level - The security level assigned to the group:

■

NoAuth, NoPriv - There is no authentication or encryption used in

SNMP communications. (This is the default for SNMPv3.)

■

Auth, NoPriv - SNMP communications use authentication, but the

data is not encrypted.

■

Auth, Priv - SNMP communications use both authentication and

encryption.

◆

Read View Name - The configured view for read access. (Range: 1-32

characters, ASCII characters 33-126 only)