User`s manual

– 230 –
C HAPTER 5 | Monitoring the Switch
Displaying Information on LACP
◆ Partner System ID – LAG partner's system ID (MAC address).
◆ Partner Key – The Key that the partner has assigned to this LAG.
◆ Last Changed – The time since this LAG changed.
◆ Local Ports – Shows the local ports that are a part of this LAG.
WEB I NTE R FACE
To display an overview of LACP groups active on this switch, click Monitor,
LACP, System Status.
Figure 107: LACP System Status
DISPLAYING LACP
PORT S TATUS
Use the LACP Port Status page to display information on the LACP groups
active on each port.
P ATH
Monitor, LACP, Port Status
P ARAM ETE R S
These parameters are displayed:
◆ Port – Port Identifier.
◆ LACP – Shows LACP status:
■
Yes – LACP is enabled and the port link is up.
■
No – LACP is not enabled or the port link is down.
■
Backup – The port could not join the aggregation group but will
join if other port leaves. Meanwhile it's LACP status is disabled.
◆ Key – Current operational value of the key for the aggregation port.
Note that only ports with the same key can aggregate together.
◆ Aggr ID – The Aggregation ID assigned to this LAG.
◆ Partner System ID – LAG partner's system ID assigned by the LACP
protocol (i.e., its MAC address).
◆ Partner Port – The partner port connected to this local port.