User`s manual

– 187 –
C HAPTER 4 | Configuring the Switch
Quality of Service
Figure 78: Configuring DSCP-based QoS Ingress Classification
CONFIGURING DSCP
T RANSLATION
Use the DSCP Translation page to configure DSCP translation for ingress
traffic or DSCP re-mapping for egress traffic.
P ATH
Configuration, QoS, DSCP Translation
P ARAM ETE R S
These parameters are displayed:
◆ DSCP – DSCP value. (Range: 0-63)
◆ Ingress Translate – Enables ingress translation of DSCP values based
on the specified classification method.
◆ Ingress Classify – Enable Classification at ingress side as defined in
the QoS Port DSCP Configuration table (see page 184).
◆ Egress Remap DP0 – Re-maps DP0 field to selected DSCP value. DP0
indicates a drop precedence with a low priority.
◆ Egress Remap DP1 – Re-maps DP1 field to selected DSCP value. DP1
indicates a drop precedence with a high priority.