User`s manual

–

178

–

HAPTER

4 | Configuring the Switch

Quality of Service

3. Set the tag classification mode to Disabled to use the default QoS class

and DP level for tagged frames, or to Enabled to use the mapped

versions of PCP and DEI for tagged frames.

4. Click Save.

Figure 71: Configuring Ingress Port Tag Classification

CONFIGURING E

GRESS

PORT S

CHEDULER

Use the QoS Egress Port Schedulers page to show an overview of the QoS

Egress Port Schedulers, including the queue mode and weight. Click on any

of the entries in the Port field to configure egress queue mode, queue

shaper (rate and access to excess bandwidth), and port shaper.

ATH

Configuration, QoS, Port Scheduler

PARAMETERS

These parameters are displayed:

Displaying QoS Egress Port Schedulers

◆

Port – Port identifier.

◆

Mode – Shows the scheduling mode for this port.

◆

Weight – Shows the weight of each egress queue used by the port.

Configuring QoS Egress Port Scheduler, Queue Scheduler and Port Shapers

◆

Scheduler Mode – The switch can be set to service the queues based

on a strict rule that requires all traffic in a higher priority queue to be