User`s manual
–
119
–
C
HAPTER
4 | Configuring the Switch
Configuring the Spanning Tree Algorithm
◆
Rapid Spanning Tree Protocol
1
RSTP supports connections to either STP or RSTP nodes by monitoring
the incoming protocol messages and dynamically adjusting the type of
protocol messages the RSTP node transmits, as described below:
■
STP Mode – If the switch receives an 802.1D BPDU (i.e., STP BPDU)
after a port’s migration delay timer expires, the switch assumes it is
connected to an 802.1D bridge and starts using only
802.1D BPDUs.
■
RSTP Mode – If RSTP is using 802.1D BPDUs on a port and receives
an RSTP BPDU after the migration delay expires, RSTP restarts the
migration delay timer and begins using RSTP BPDUs on that port.
◆
Multiple Spanning Tree Protocol
MSTP generates a unique spanning tree for each instance. This provides
multiple pathways across the network, thereby balancing the traffic
load, preventing wide-scale disruption when a bridge node in a single
instance fails, and allowing for faster convergence of a new topology for
the failed instance.
■
To allow multiple spanning trees to operate over the network, you
must configure a related set of bridges with the same MSTP
configuration, allowing them to participate in a specific set of
spanning tree instances.
■
A spanning tree instance can exist only on bridges that have
compatible VLAN instance assignments.
■
Be careful when switching between spanning tree modes. Changing
modes stops all spanning-tree instances for the previous mode and
restarts the system in the new mode, temporarily disrupting user
traffic.
P
ARAM
ETE
R
S
These parameters are displayed:
Basic Settings
◆
Protocol Version – Specifies the type of spanning tree used on this
switch. (Options: STP, RSTP, MSTP; Default: MSTP)
■
STP: Spanning Tree Protocol (IEEE 802.1D); i.e., the switch will use
RSTP set to STP forced compatibility mode.
■
RSTP: Rapid Spanning Tree (IEEE 802.1w)
■
MSTP: Multiple Spanning Tree (IEEE 802.1s); This is the default.
1. STP and RSTP BPDUs are transmitted as untagged frames, and will cross any VLAN
boundaries.