User`s manual

54
Parameter Usages:
-print show versions of all rom files
-app, boot, dsptest, dspcore, dspapp to update main Application
program code, Boot code, DSP testing code, DSP kernel
code, or DSP application code.
-boot2m boot2m parameter let users to upgrade the whole
system flash, including all the firmware that mentioned
above. If 2M rom file update is executed, users have to
set again the MAC address of Micronet FXO
Gateway or it will cause conflict on Ethernet
because the original MAC address is erased during
2M ROM file upgrading.
Note: To set mac address please key in command setmac:(when key
in MAC address ,press enter each time after key in two characters):
usr/config$ setmac
- enter mac address (xxxxxxxxxxxx):
0001a8002baa
- the mac address is 00 01 a8 00 2b aa
- if mac address is correct,please press 'y' to
setup configuration,else press 'n' to continue
y
-greeting The greeting file can be updated by users. The attributes
of sound file should complied to: μ-law, 8000 Hz , 8 bit,
Mono, 7 kb/s
-askpin update ASKPIN sound file. This is the greeting sound
that when asking for pincode.
-s to specify TFTP server’s IP address when upgrading
ROM files.
-f to specify the target file name, which will replace the old
one.
-method to decide using TFTP or FTP as file transfer server. “0”
stands for TFTP, while “1” stands for FTP.