User`s manual

-t38 T.38(FAX) enabled/disabled.

-t38ecm T.38(FAX) ECM enabled/disabled.

-fstart Fast start enabled/disabled.

-tunnel H245 Tunneling enabled/disabled.

-h245fs H245 separate channel after faststart.

Example:

support -t38 1

support -t38ecm 1

support -fstart 1

support -tunnel 0

support -h245fs 1

usr/config$

Parameter Usages:

-print print current setting in support command.

-t38 to switch ON/OFF (1 = ON; 0 = OFF) T.38 function.T.38

function is for FAX. If user will use FAX machines,

please switch on T.38 function.

-t38ecm to disable/enable T.38 error correction mode. This mode

support error correction during fax high-speed mode.

-fstart to switch ON/OFF (1 = ON; 0 = OFF) FastStart function.

Fast Start function can shorten the connection time if the

opposite party also supports FastStart.

-tunnel to switch ON/OFF (1 = ON; 0 = OFF) H.245 tunneling

function. If the function is ON, Micronet FXO Gateway

will send H.245 (Call Control messages) via H.225’s

(Call Signal messages) link. The function is effective

only when both side support h245 tunnel.

-h245fs to set if open H.245 separate channel after fast start or

not. (1 = ON; 0 = OFF)

Note:

1. It is not recommended to change the value in this command, only

if users do know well the application. This might cause