User`s manual

-askpin:

0Æ disables ASKPIN function

1Æ enables ASKPIN function, and apply to the whole

unit. Every channel uses the same PINCODE.

2Æ enables ASKPIN function, and apply to each

channel respectively. Every channel uses a different pin

code.

-ring To set when dial in Micronet FXO Gateway from PSTN

side, Micronet FXO Gateway will pick the call

immediately or rings for specific times before picks up.

0 Ædisable: pick up immediately

1-5 Ætimes of ring before Micronet FXO Gateway picks

up.

- keypad keypad type when relay DTMF signal.

0 Æ In-Band

1 Æ h.245 alphanumeric

2 Æ h.245 signal type

3 Æ q.931 user info

4 Æ RFC2833.

- pincode to specify pin codes.

- cid to disable or enable Bellcore format caller ID. If user

enables this function, Gateway will receive caller ID and

pass it through. (Note: only FSK type of caller ID is

available.)

- faxrdd To add the redundancy depth in fax when the network is

not in a good quality. (sysconf -faxrdd 2 ;0:default / 1:first

level in depth / 2:highest level in depth)

Note: It will take more bandwidth if the depth level is the highest in 2.

4.2.15 [h323] command

This command is to configure H.323 related parameters.

usr/config$ h323