User`s manual

38
sysconf -2nddial 0 -drule out_filter 002 in_insert x in_drop 1
sysconf -askpin 1 -pincode set1 12345
usr/config$
Parameter Usages:
- service:
0Æ Dial In Service
In Dial-In-Service, Micronet FXO Gateway will pick up incoming
calls from PSTN, play pre-recorded voice greeting or, and then
have users to make a 2
nd
dial to destination.
1/2 Æ HotLine Service (this feature must be implemented after set
bureau –table command)
HotLine Service provides Hot Line function, which connects
directly to pre-defined destination. For ex: if L1 of Micronet FXO
Gateway is assigned to destination address 192.168.1.12 in
Hot Line Mode. When users from PSTN make a call to L1 of
Micronet FXO Gateway, it will directly connect to 192.168.1.12
without a 2
nd
dial.
3 Æ The connect signal will sent to IP side if gateway detect the
reverse signal. It is using the billing application.
- ringdet To define ring detection method. (0 is for old hardware
version; 1 for new hardware version)
- plan It is for setting dial-numbering plan. While e164 number
is three digits, the plan should be set as 3 or 0. The plan
0 is for any positive digits use.
- port This command can enable or disable individual port. The
default value is set to enable all ports.
- idto The duration of two pressed digits in dial mode
- eod Digit type of end of dialing. (0:No end of dialing, 1:[*]