User`s manual

37
-ringdet Specify Gateway ring detect method. (0:For 1st hardware version,
1:For 2st hardware version.
-plan Number of digits for dial plan. (any positive number.)
-port Enable/Disable individual port.
-idto The duration of two pressed digits in dial mode
-eod Digit type of end of dialing. ( 0:No end of dialing, 1:[*] button, 2:[#]
button )
-seizure Choose line seizure mode (None/UCD).
-2nddial Config GW to accept 2nd dtmf set. In this mode, device from IP side
needs to dial GW's E164, wait for PSTN dial tone, and then dial out.
-drule Specify digits to be filtered/dropped/inserted before making an
outgoing IP call or after receiving an incoming IP call.
-askpin PIN code prompt before greeting.
0:Disable 1:Per Unit 2:Per Channel.
-ring Ring number before answer.
0:Disable, other is number of ring ( 1 ~ 5 ).
-keypad DTMF setting: 0=In-band, 1=H.245 Alphanumeric, 2=H.245
SignalType, 3=Q.931 UserInfo. , 4=RFC2833.
-pincode Specify PIN codes.
-cid Specify caller id type.(0:diable 1: Bellcore)
-faxrdd FAX redundancy depth.(0 ~ 2)
Note:
Use character 'x' to delete the drule parameter.
For line seizure 0: None, 1: UCD.
For askpin: f=0: No, f=1: Yes, f=2: per channel
Hotline feature should be used together with:
$sysconf -2nddial 0 (2nddial off)
$h323 -mode 1 (peer-to-peer mode)
$bureau -print for Hotline/LineToLine table configuration.
LineToLine feature should be used together with:
$sysconf -2nddial 1 (2nddial on)
$h323 -mode 1 (peer-to-peer mode)
$bureau -print for Hotline/LineToLine table configuration.
Example:
sysconf -service 0 -plan 4 -port 1 1 1 1 0 0
sysconf -callalive 0 -keypad 0