User`s manual

26
Parameters Usage:
-print print current IP setting
-ip assigned IP address for Micronet FXO Gateway
-mask internet subnet mask
-gate IP default Gateway
-dhcp Dynamic Host Configuration (1 = ON; 0 = OFF)
-sntp Simple Network Time Protocol (1 = ON; 0 = OFF) When
SNTP function is activated, users have to specify a SNTP
server as network time source. An example is
demonstrated below:
usr/config$ ifaddr -sntp 1 10.1.1.1
while 10.1.1.1 stands for SNTP server’s IP address.
-http Change http port. User can change default HTTP port(80)
to another one for security or NAT application.
-dns Set DNS server IP address. User can set one or two sets
of DNS server. (ifaddr –dns 1 “primary DNS server IP
address” ; ifaddr –dns 2 “secondary DNS server IP
address”)
-timezone Set timezone for Micronet FXO Gateway. User can set
different time zone according to the location Micronet FXO
Gateway is. For example, in Taiwan the time zone should
be set as 8,which means GMT+8.
-cmcenter Set management center IP address. IF user specifies
management center IP address, Micronet FXO Gateway
will send information to management center, let user can
easily configure via management center interface.
(sysconf –cmcenter “IP address of management center”)
Note: management center is optional software to help user can easily
configure Micronet products, please contact your reseller to know
more about it.
-ipsharing Specify usage of an IP sharing device and specify IP
address. If Micronet FXO Gateway is behind an