User`s manual

23
And turn back to login prompt.
usr/config$ quit
Disconnecting...
login:
Note: It is recommended that type the “quit” command before you
leave the console. If so, Micronet FXO Gateway will ask password
again, when next user connects to console port.
4.2.3 [debug] command
Open debug message will show up specific information while Micronet
FXO Gateway is in operation. After executing the debug command, it
should execute command debug -open as well. One example is
demonstrated below.
usr/config$ debug -add h323 vp
usr/config$ debug -open
Parameters Usage:
-status Display the enabled debug flags.
-add Add debug flag.
-- h323 : h323 related information
-- vp : voice related information
-delete Remove specified debug flag.
-open Start to show debug messages.
-close Stop showing debug messages.
4.2.4 [reboot] command
After commit command, type reboot to reload Micronet FXO
Gateway in new configuration. The procedure is as below:
usr/config$ reboot
Attached TCP/IP interface to cpm unit 0
Attaching interface lo0...done
AC4804[0] is OK
AC4804[1] is OK