User`s manual

phone -rbt 480 440 8 8 2000 4000 2000 4000
phone -bt 620 480 8 8 500 500 500 500
phone -dt 440 350 8 8 500 1023 1023 1023
phone -flash 100 300
usr/config$
Parameters Usage:
-print print current call progress tone configurations (ring – ring
tone, rbt – ring back tone, bt – busy tone, dt – dial tone,
flash – flash ). This parameter should be accompanied with
tone type. For example:
-----------------------------------------------------------------------------------------------
usr/config$ phone -print rbt
Phone ring back tone parameter
Ringback Tone frequency high : 480
Ringback Tone frequency low : 440
Ringback Tone frequency high level : 13
Ringback Tone frequency low level : 13
Ringback Tone tone1 on : 100
Ringback Tone tone1 off : 200
Ringback Tone tone2 on : 1023
Ringback Tone tone2 off : 1023
usr/config$
Note:
For tone simulation, Gateway adopts dual frequencies as traditional
telephone does. If users want to have their own call progress tone, they
can change the value of tones. High and Low frequency/level/cadence
can be configured respectively.
-ring to set RING tone value.
The played tone type, when Gateway is receiving a call.
-rbt to set RingBackTone value
The played tone type, when Gateway receives a Q.931 Alerting
message. In condition that Gateway is the originate side.
-bt to set BusyTone value.
The played tone type, when destination is busy.
71