User`s manual

5.13 [line]
This command is for configure each line parameters of Gateway.
----------------------------------------------------------------------------------------------
usr/config$ line
Gateway line information and configuration
Usage:
line -config number [hunt number][hotline number][forward number]
line -print Gateway line information.
hunt Hunting group.
hotline Hot line configuration.
forward No answer forward for FXS line.
Example:
line -config 1 hunt 1 hotline 1003 forward 1002
usr/config$
Parameter Usages:
-print print out all current settings of line
-config determine which line to configure
-hunt set hunting group flag of each line. User can assign different
hunt group number represent different hunt group. For
example, if user assigns FXS TEL1 as hunt group 1, and FXS
TEL2 as hunt group 2, they will be determined as 2 different
groups. On the other hand, if user assigns FXS TEL1 as hunt
group 1, and FXS TEL2 as hunt group 1 too, when having
incoming call to FXS TEL1, which is busy, this call will be
route to FXS Line2.
Note: FXO Lines and FXS TELs are treated as 2 different
groups, so even they are in the same hunt group, call will only
be routed to the same FXS or FXO Lines.
-hotline set hotline table. The Hotline Mode is applied in limited two
channels. User just picks up the phone set of one FXS TEL or
calls in one FXO line, and gateway will automatically dial out
a phone number. In the other hand, user will hear ring back
tone or dial tone immediately depended on configurations of
destination device. Note: This function can both work in
59