User`s manual

-expire The relative time after which the message expires
(0~65535).
-port SIP local UDP port number (5060~5070). Default :
5060
-rtp RTP port number (2326~65532). Default : 16384
Example:
sip -px 210.59.163.171 -line1 70 -line2 71 -line3 72 -line4 73
usr/config$
Parameters Usage:
-print print current h323 related settings
-mode alternatives for proxy or peer-to-peer mode (1=proxy mode;
0=peer-to-peer mode). If users select proxy mode, a valid
proxy is needed when Gateway is in operation.
-----------------------------------------------------------------------------------------------
usr/config$ sip –mode 0 (peer to peer mode)
-px to assign the ip address of the proxy when Gateway is in
proxy mode.
-domain to assign the domain name of the proxy when it is needed.
-prefix this will be prefix the alphabets before the sip line number.
-line1 assign FXS TEL1 number.
-line2 assign FXO Line1 number.
-line3 assign FXS TEL2 number.
-line4 assign FXO Line2 number.
Note:
User can also set “x” in line number to disable the port. If the port is
disabled, it can only receive calls but not calling out.
Note:
1. This is for SP5014/S, for SP5012/S, there are only line1 and line2
command.
2. No matter in Proxy or P2P mode, user only needs to dial line number
to reach local port. For example, in P2P mode, user wants to dial from
FXS TEL1 to FXO Line1, only need to dial number of line2.
57