User`s manual

-eod End of dial.(Enable: 1 / Disable : 0)
Example: sysconf -ring 500
usr/config$
Parameters Usage:
-print print out all current settings
-idtime set the duration (in second) of two pressed digits in dial
mode as timed out. If after the duration user hasn’t pressed
next number, it will dial out all number pressed. (1-10
seconds)
-forwardtime set forward time (5-65535 seconds) for FXS Line. If callee
hasn’t answered the call in this time, call will be forward to
assigned number in [line] command. (Please refer to [line]
command for forward setting)
-keypad DTMF replay type. When value is “0”, Gateway will transfer
DTMF signal via In-Band type, “1” via RFC2833 type. Users
can adjust the value according to various applications.
1. Number (instead of Line number of FXO Line)+ PSTN
number to make a call to PSTN side connected with
FXO Line.
2. After gateway-prefix-drop function is enabled, user must
remember to re-configure line number of FXS Line,
because line number of FXS Line must remove prefix
number. For example, origin line number of FXS line is
1001, prefix is 100, since prefix number will be drop,
once gateway has incoming call 1001, after drop
gateway prefix 100, it will search line number “1”. So line
number must be set as “1”.
-hwtype application rom file of 37 series are the same no matter how
many ports is the module, so after user downloads the
application rom file, user can select which hardware type
is . ”0” means gateway will automatically detect the hardware
type, “1” means the hardware type is 1FXS+1FXO, “2” means
the hardware type is 2FXS+2FXO.
Note:
The default value is to auto detect hardware type. Usually it is not
necessary to change this setting. Please make sure about your Hardware
55