User`s manual

42
5. IVR / Keypad Management
You can use the PSTN phone keypad to operate the IP Telephony gateway.
Please follow the instruction to configure.
IVR Action IVR Menu
Choice
Parameter(s) Notes
Dial out from
PSTN Line
0# None
Press 0# can pass relay to
PSTN Line, user can dial
out from PSTN Line.
(SP5001D only)
Unlock keypad
setting
#190# None
After you unlock keypad
setting, then you may
configure the ATA.
Reboot #195# None
After you hear “Option
Successful,” hang-up. The
system will reboot
automatically.
Factory Reset #198# None
System will automatically
Reboot.
WARNING!!
ALL “User-Changeable”
NONDEFAULT SETTINGS
WILL BE LOST! This will
include network and service
provider data.
Check WAN IP
Address
#126# None
IVR will announce the
current WAN IP address of
the gateway.
Check LAN IP
Address
#120# None
IVR will announce the
current LAN IP address of
the gateway.
Check IP Type #121# None
IVR will announce if DHCP
in enabled or disabled.
Check the Phone
Number
#122# None
IVR will announce current in
use VoIP number.
Check Network
Mask
#123# None
IVR will announce the
current network mask of the
gateway.
Check Gateway
IP Address
#124# None
IVR will announce the
current gateway IP address
of the gateway.
Check Primary
DNS Server
Setting
#125# None
IVR will announce the
current setting in the
Primary DNS field.
Check Firmware
Version
#128# None
IVR will announce the
version of the firmware
running on the gateway.
Set DHCP client #111# None
The system will change to
DHCP Client type
Set Static IP
Address
#112xxx*xxx*x
xx*xxx#
Enter IP address using
numbers on the
telephone keypad.
DHCP will be disabled and
system will change to the
Static IP type.