User`s manual

Chapter 2 Installation

2.1 Hardware Installation

This section describes how to install the Modem and establish network

connections. Users may install the Modem on any level surface. However,

please take note of the following minimum site requirements.

2.2 Pre-installation Requirements

Prior to the start of actual hardware installation, make sure users can provide

the right operating environment, including power requirements, sufficient

physical space, and proximity to other network devices that are to be

connected.

Verify the following installation requirements:

y Power requirements: DC 5V/1A or above.

y The Modem should be located in a cool dry place with at least 10cm

of space at the front and back for ventilation purpose.

y Place the Modem out of direct sunlight, and away from heat sources

or areas with a high amount of electromagnetic interference.

2.3 Cabling Requirements

Before making any connections to the Modem, note the following rules:

Connection Type Cable Requirements Maximum Length

Ethernet Port (RJ-45)

y 100 Mbps: Cat 5 UTP

y 10 Mbps: Cat 3-4 UTP

100 meters max for MUX

or HUB to endpoint.