User`s manual

32
 PPP User Name: User name for PPPoE dialup. It is provided by your ISP.
 PPP Password: The password provided by your ISP for PPPoE dialup.
 PPPoE Service Name: it is provided by your ISP. Do not fill it in if you don’ t have it;
otherwise PPPoE dialup may fail.
 Authentication Method: it is used by ISP to verify its clients during PPPoE dialup.
Select “ Auto” if you are not sure about it.
 Clone MAC：This feature clones the MAC address of the PC that is currently entering
the router’ s management page to work as the WAN MAC address of the router.
 Dial on Demand: Automatically connects or disconnects Internet according to the use
of the network. It is recommended when your ISP limits network use time.
 PPP IP extension: The IP addresses of all packets including management packets that
egress WAN port will be converted to the WAN port’ s IP address once this feature is
enabled.
 Enable PPP Debug Mode: This feature can be enabled only when supported by your
ISP.
 Bridge PPPoE Frames Between WAN and Local Ports：PPPoE dialup frame initiated
by LAN port will directly egress WAN port without being modified if this feature is
enabled.
 Multicast Proxy: Router enables multicast proxy server if this feature is enabled.
Enter the PPP user name and PPP Password provided by your ISP. For other options,
keep the default values if you are not clear about them, and then click the “ Next” button
to display the following screen (page 4):
Page 4
This page allows you to configure the gateway address for WAN connection. We
recommend you to keep the default values and click the “ Next” button on page 4 to
enter the following page (page 5):