User`s manual

30
On this page, you can configure VPI and VCI values (consult your local ISP if you are not
clear). For other options, keep the defaults and click the “ Apply/Save” button.
2. In Ethernet modes, you are required to configure parameters for Ethernet interface.
To enter the ETH Interface page, click “ Advanced Setup” ---“ Connection Mode”
(Select Ethernet mode and click “ Apply” ) --- “ WAN Service” ---“ ETH Interface” .
And then click the “ Add” button to configure relevant parameters.
The Ethernet interface configured on this page is used as a WAN port. You can select only
one LAN interface to function as a WAN port. Once you finish, click the “ Apply/Save”
button.
4.3.3 WAN service
WAN Configuration in DSL Mode
-PPP over Ethernet (PPPoE)
Click “ Advanced Setup” —“ Connection mode” (Select DSL mode and click
“ Apply” )---“ WAN Service” ---“ ATM Interface” (refer to 4.3 for configuring the ATM