User`s manual

Service/Routing/DNS/DSL/UPnP/ Interface Grouping and Multicast as shown in the figure

below:

4.3.2 Connection mode

Connection Mode

This router supports two connection modes: DSL mode and Ethernet mode. Select DSL

mode, if you access Internet through telephone line and Ethernet mode through network

cable. By default, system is in DSL mode.

To enter the connection mode interface, click “ Advanced Setup” ---“ Connection

Mode” . Select a proper connection mode and then click the “ Apply” button.

1. In DSL mode, you are required to configure parameters for ATM interface.

To enter the ATM Interface page, click “ Advanced Setup” ---“ Connection Mode”

(Select DSL mode and click “ Apply” )--- “ WAN Service” ---ATM Interface. And then

click “ Add” to configure the relevant parameters.