User`s manual

27
In the above figure, 2 SP3367NLs are used to enlarge wireless signal coverage.
SP3367NL-2 is configured as a wireless bridge to establish a wireless bridge with
SP3367NL-1. SP3367NL-2, here, does not have the AP function, thus, PC3 and PC4 can
communicate with SP3367NL-2 and access Internet only through wired network adapters
instead of wireless ones.
Note: To use wireless bridge, you must disable wireless encryption.
Bridge Restrict：There are 3 options available: Enabled, Enabled (Scan) and Disabled.
Enabled: Select it to enable wireless bridge function. You need to know the MAC address
of a remote bridge and enter it manually. 4 MAC addresses of remote bridges can be
saved to simultaneously establish bridges with 4 APs.
Enabled (Scan): Select it to enable the wireless bridge function. In the meantime, system
will automatically scan MAC addresses of available wireless devices. See the figure below: