User`s manual

24
Enable WPS: check/uncheck to enable/disable the WPS function. It is enabled by default.
Note: The WPS feature only functions with wireless network available.
Network Authentication: To secure your wireless network, system provides several
authentication modes:
Open: you can select “ no encryption” or WEP（64 bits/128 bits）as encryption
algorithm.
Shared: You can select WEP 64 bits/ WEP 128 bits as encryption algorithm.
WPA-PSK: You can select AES, TKIP or TKIP+AES as encryption algorithm.
WPA2-PSK: you can select AES, TKIP or TKIP+AES as encryption algorithm.
Mixed WPA/ WPA2-PSK: you can select AES, TKIP or TKIP+AES as encryption algorithm.
4.2.3 MAC Filter
MAC address filter can allow or refuse specific clients to access your wireless network,
see the screen below:
“ Disabled” : Select it to disable MAC filter function.
“Allow”: only allows clients in the MAC address list to access your wireless network.
“ Deny” : only prohibits clients in the MAC address list from accessing your wireless
network.
Add: to add a MAC address, click the “ Add” button.
To delete an added MAC address, first check the “ Remove” box behind the MAC
address in list and then click the “ Remove” button.
Example 1: If you want to allow the PC with MAC address of 00:1A:3D:9C:BB:23 only to
access your wireless network, then follow the instructions below:
Click the “ Add” button in the above screen to enter the page below and enter the MAC
address 00:1A:3D:9C:BB:23 in the text box as shown in the below figure: