User`s manual

Secondary DNS
Server IP Address
IP address of the secondary Domain Name Server in dot
notation. It will be used in case the Primary DNS Server
cannot be contacted.
Remote Console And
HTTPS port
Port number at which the SP1200A's Remote Console server
and HTTPS server are listening. If left empty the default value
will be used.
HTTP port
Port number at which the SP1200A's HTTP server is listening.
If left empty the default value will be used.
Telnet port
Port number at which the SP1200A's Telnet server is
listening. If left empty the default value will be used.
SSH port
Port number at which the SP1200A SSH (Secure SHell)
server is listening to. If left empty the default value (port 22)
will be used.
Bandwidth limitation
The maximum network traffic generated through the SP1200A
Ethernet device. Value in Kbit/s.
Enable Telnet access This enables the Telnet function.
Enable SSH access This enables the SSH (Secure SHell) function.
Disable Setup
Protocol
Enable this option to exclude the SP1200A from the setup
protocol. Setup protocol is a proprietary layer-2 MAC-based
protocol to allow some configuration software to detect
SP1200A devices in the network, even without IP address,
and then config network related settings to SP1200A.
LAN Interface Settings
The “Autodetect” will set the Ethernet speed to the fastest
possible value supported by both endpoints of the link. For
example, if you use a 10M/half duplex HUB, this speed will be
auto-selected. If this option does not work with some network
device (HUB, switches, and routers), you can set the Ethernet
interface speed of SP1200A manually to the values as
supported by the network device.
4.6.2 Dynamic DNS
A freely available Dynamic DNS service (www.dyndns.org) can be used in the
following scenario.
52