User`s manual

Parameter Description
None
Select this option to setup a fixed IP address for the IP KVM
switch. After selecting ‘None’, enter the desired IP address,
Subnet Mask and Gateway.
BOOTP
A static configuration protocol uses a table that maps IP
addresses to physical addresses.
DHCP
An extension to BOOTP that dynamically assigns
configuration information. DHCP is backward compatible with
BOOTP.
Super User Login
Enter the login name of the super user. The initial value is
“super”. All characters are in lower case.
Super user password
Enter the current password for the super user. This initial
value is “pass”. All characters are in lower case.
New super user
password
Enter the new password for the super user.
New password
(confirm)
Re-type the new password for the super user for confirmation.
Click on <Setup Device> button to apply the new settings on IP KVM Switch.
3.2 Configuration Setup via Serial Console
For using serial terminal, the SP1200A has a serial line interface (host side).
This connector is compliant with the RS-232 serial line standard. The serial
line has to be configured with the parameters given in Table below.
Parameter Value
Bits/second 115200
Data bits 8
Parity No
Stop bits 1
8