Owner`s manual

PlatinumNAS Owner’s Manual
44
Resetting the PlatinumNAS
Should the PlatinumNAS become inaccessible (blinking fault light, forgotten password) or if
directed by MicroNet support, please follow the below procedure to reset the PlatinumNAS
to factory default:
1. If the unit is functioning, ping the PlatinumNAS from the host to
obtain its IP address. Write down the IP address.
2. Shut down the PlatinumNAS and disconnect the Ethernet cable(s)
3. Power on the PLATINUMNAS and immediately deClick and hold the
reset button (circled right)
4. Continue to hold the reset button until the PlatinumNAS emits a
loud beep (approximately 2 minutes).
6. Plug the Ethernet cable back into LAN port 1.
7. Navigate your Explorer or browser window to HTTP://XXX.XXX.
XXX.XXX (where the X’s represent the PlatinumNAS’s IP address.)
8. You will see a simple dialog box that has three options:
Choose Reset to Factory Default and click Apply. Click “Yes” in the confirmation dialog box.
9. You should see a confirmation dialog pop up telling you that the PLATINUMNAS is reset.
Reboot the PlatinumNAS to complete the procedure.
6-Troubleshooting