Owner`s manual

PlatinumNAS Owner’s Manual

3-Administering the PlatinumNAS

5.5 Module Management

MicroNet strives to continually improve and

from time to time will release additional

features, or modules, for the PlatinumNAS.

Modules offer additional functionality without

replacing the base operating code, or firmware.

Modules will either be made available on

MicroNet’s website or provided by MicroNet

Technical Support. To access the module management, navigate to “System” -> “Module

Mgmt”.

• To install a new module, click the “Browse” button next to the Module File entry box.

Navigate and select the module file. Click “Install” to begin the upload, and confirm the

operation in the following confirmation dialog.

• To enable, disable, or uninstall a module, check the checkbox left of the module and click

the respective function button (Uninstall), (Enable), or (Disable). confirm the operation in

the following confirmation dialog.

5.6 Reset to Factory Default

Should it become necessary to reset all settings to

factory default, access the Reset to Factory Settings

screen from “System” -> “Factory Default.” Click the

“Apply” Button to reset the unit, and confirm the

operation in the following confirmation dialog.

5.7 Update Firmware

MicroNet strives to continually improve

and from time to time will release firmware

updates for the PlatinumNAS.

Firmware will either be made available

on MicroNet’s website or provided by

MicroNet Technical Support. To access the

Firmware Upgrade, navigate to “System”

-> “Firmware Upgrade”. Click the “Browse” button

next to the Firmware entry box. Navigate and

select your saved settings file. Click “Apply” to

begin the upload, and confirm the operation in the

following confirmation dialog.

5.8 Change Administrator Password

To change the administrator password, navigate to “System” -> “Administrator Password” and

the Administration password screen appears. Enter the new password in the “New Password”

field, and re-enter the password (case sensitive) in the “Confirm Password” field. When both

fields are entered, click the “Apply” Button to confirm, or the “Cancel” button to abort.

WARNING: Resetting to factory default will

erase all data!

IMPORTANT: Make sure all user data and

system settings are backed up before updating

ﬁrmware!