User guide

Entry Level Wind System
6
www.tacktick.com
English
Installing the Wind Transmitter
See the separate installation guide for the Wind Transmitter.
Calibration
After installation, the Wind Angle should be calibrated:
Motor the vessel directly into the wind.
Go to the Wind Angle page in Setup (see page 3)
Press
Use and to bring the lower larger digits to
000ยบ. The upper smaller digits show the number of degrees of
offset entered.
Press to exit Edit Mode
Press and hold to exit Setup.
Maintenance
To clean, use only a damp, soft cloth. No detergents, solvents or abrasives
should be used. Use of chemicals will invalidate the warranty. Ensure the
sun cover is fitted to the instrument when cleaning the boat.
Fault Finding and Correction
Data is shown as dashes.
Communication between the Wind Transmitter and the Wind Display may
have been lost. Switch off the system, wait for thirty seconds and switch on.
Enter Setup (page 2) and scroll to the Health Chapter. Check the signal level
of the Wind Transmitter. '--.-' displayed means no communication from the
Wind Transmitter. A value after the decimal place will indicate a signal
strength 0-9, nine is strongest.
Wind speed is shown as zero.
If the anemometer cups are turning and the wind speed is shown as 0 then
there is a problem with your Wind Transmitter.
Lost Network alarm sounds
This can only occur if there is more than one Micronet display on your
network. The display showing the alarm has lost communication with the
Master. The display will power down shortly after sounding the alarm.
This may occur when powering down the system by switching off at the
breaker, this does not indicate a problem. In other cases, switch off the
system, wait for thirty seconds and switch back on.