Technical information

4 © 2010 Schneider Electric. All rights reserved. F-26266-7
Mounting
Panel or DIN Rail Mounting
1. Select mounting location. Enclosure mounting is recommended.
2. Do one of the following:
a. Using two #6 pan head screws, mount base of controller to a panel (Figure-1).
b. Snap controller base on a 35mm DIN mounting rail (not provided). Multiple units can
be mounted side by side on a DIN mounting rail.
3. Wire controller base (See Wiring section).
4. After wiring, insert cover tabs into brackets on base of the controller and gently push
until cover snaps into place.
Figure-1 Mounting Dimensions.
4-3/8 (111)
4-5/16
(109)
2
(51)
3 (76)
Base View
1-13/32
(36)
Dimensions shown are in inches (mm).
2 (51)
1-13/32
(36)
Side View