Specifications

4 Seatrial and Calibration

Once the Micronet system has been Autonetworked and installation on

the vessel has been completed it is necessary to carry out calibration.

It is not safe to use the displays for navigational purposes until

calibration has been carried out correctly.

4.1 Wind Calibration

Both wind speed and direction can be calibrated to ensure that readings

from the Wind Transmitter are displayed accurately.

Wind Angle Offset

Motor the vessel directly into the wind.

Press and hold the button for 2 seconds to enter Setup

Press the button repeatedly to scroll to the WIND chapter

Press button to move to the Wind Angle Offset page

Press the button to enter Edit Mode

Press the and buttons to change the displayed value

to 000.

The upper digits will indicate the number of degrees of offset entered.

Press the button to exit Edit Mode

Press and hold the button to exit Setup.

Wind Speed Correction

Note: Wind speed reading is factory calibrated to display correctly and should

not be altered unless external factors are thought to be causing incorrect

readings. Correction should only be carried out if a known correct

windspeed is available.

Press and hold the button for 2 seconds to enter Setup

Press the button repeatedly to scroll to the WIND chapter

Press the button to advance to the page

Press the button to enter Edit Mode

Press the and buttons to change the displayed value

to the required percentage.

The lower digits will indicate the displayed wind speed.

Press the button to exit Edit Mode

Press and hold the button to exit Setup.

mn100 Analogue Display