Specifications

s10 Boat Show

Allows the display of information when NOT installed as part

of a Micronet system for demonstration purposes only.

Off / On.

s11 LCD Contrast

Adjusts the viewing angle and contrast of the LCD display to

improve visibility under varied mounting possibilities.

Optional values 1 - 7, default 4.

s12 Pointer Type

Toggles the width of the pointer.

If the viewing position is more than 1 metre away from the

analogue display, then the viewability can be improved by

selecting the wider pointer type.

s13 Factory Reset

Returns all the calibration settings to the factory default

values.

HLTH - Health Chapter

s14 Software Version / Network Nodes

Shows the display’s software version, battery level and

charge rate to assist in troubleshooting and fault finding.

If the display is the "Master" (the one used to switch on the

system) then the number of items (nodes) in the system will

be shown.

If the display is a "Slave" (was switched on by the system) then the signal

strength to the "Master" will be shown.

s15 Hull Transmitter Signal Strength

Shows the software version (before the decimal point), signal

strength (after the decimal point) and battery condition (level

and charge rate) of the Hull Transmitter to assist in trouble

shooting and fault finding.

mn100 Analogue Display