User`s guide

Getting Started
2-8
2.4 SCSI Termination
Two 68-pin wide SCSI connectors are provided on the back of the enclosure
for connecting the array to the system. These connectors are used in one of
two ways:
 If the disk array is the only external SCSI device, or is the last external
device in a daisy-chained configuration, connect the incoming cable (the
one which is attached to the SCSI adapter) to the Host A & B in connec-
tor and install the external SCSI Terminator on the Host A & B out
connector.
 If the array is to be placed in the middle of a daisy-chained configuration,
connect the incoming cable (the one which is attached to the SCSI
adapter) to the Host A & B in connector and connect the outgoing cable
(the one which continues on to other devices) to the Host A & B out
connector. In this case, no terminator is required at the disk array but the
last device in the daisy chain must have a terminator.
HOST A out
HOST B out
+
+